© 2016 Thorlabs54
ITC8000
[1313,"Wrong command for this sensor"]
Reason: The used command is not allowed for the selected sensor, e.g., attempt to set a
thermistor resistance value, while the selected and recognized sensor is an AD590)
[1314,"No sensor change during TEC on allowed"]
Reason: The sensor type cannot be changed while the TEC output is switched on.
[1315,"Attempt to switch on laser while temperature is out of window"]
Reason: Attempt to switch on the laser while the laser temperature is outside of the temperature
window.
[1316,"Attempt to activate Twin during laser on"]
Reason: The temperature window cannot be activated while the laser output is switched on.