TC300 Heater Temperature Controller Chapter 8: Command Line Operation
Rev B, January 5, 2022 Page 39
Return:
n
8.3.24. DARK=n; DARK? – Darkness Status of TC300
DARK command is used to set and query darkness status of the TC300 Display,
DARK=n
Set darkness status of TC300 Display, when n=1, Enable, when n=0, Disable
DARK?
Query darkness status of TC300 Display, when n=1, Enable, when n=0, Disable
Return:
n
8.3.25. KB=n; KB? – Lock Status of TC300
KB command is used to set and query lock status of the TC300 knob and buttons. When lock is enabled, the TC300
will not be responding to any operation input from the knob or buttons on the front panel.
KB=n
Set lock status of TC300, when n=1, Enable, when n=0, Disable.
KB?
Query lock status of TC300, when n=1, Enable, when n=0, Disable.
Return:
n
8.3.26. KP1=n; KP1?; KP2=n; KP2? – KP Value of PID
KP command is used to set and query the P share (Gain of P) value of PID.
KP1=n
Set P share (Gain of P) value of PID for Channel 1 to n/100. The range of n is 0 to 999 with a resolution of 1.
KP1?
Query P share (Gain of P) value of PID for Channel 1, range: 0 to 9.99, resolution: 0.01.
Return:
n/100
KP2=n
Set P share (Gain of P) value of PID for Channel 2 to n/100. The range of n is 0 to 999 with a resolution of 1.
KP2?
Query P share (Gain of P) value of PID for Channel 2, range: 0 to 9.99, resolution: 0.01.
Return:
n/100
8.3.27. TI1=n; TI1?; TI2=n; TI2? – TI Value of PID
TI command is used to set and query the I share (Gain of I) value of PID.
TI1=n
Set I share (Gain of I) value of PID for Channel 1 to n/100. The range of n is 0 to 999 with a resolution of 1.
TI1?
To Next Page
Loading...
Need help?
General
