EasyManuals Logo

THORLABS TC300 User Manual

THORLABS TC300
58 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
TC300 Heater Temperature Controller Chapter 9: Maintenance
Page 44 CTN017856-D02
Chapter 9 Maintenance
9.1. Fuse Replacement
SHOCK WARNING
HIGH VOLTAGE
To avoid electrical shock, always power off the device and unplug the power cord before fuse
replacement.
The fuse is located in the fuse drawer below the power inlet. Pull out the drawer and take out the used fuse. Please
use 3.15 A, 250 VAC, Type "T”, slow blow fuses only for replacement.
.
Figure 31 Fuse Replacement
9.2. Firmware Update
Thorlabs offers downloads of firmware update files for the TC300 on the website (http://www.thorlabs.com/). To
update the controller firmware, connect the controller to a PC with the included USB cable. Keep holding down the
“ENTER” button when powering on the device until the device shows the below screen on the LCD. The device has
then entered the Bootloader mode designated for firmware updates.
Figure 32 Setting the Operation Temperature Range

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the THORLABS TC300 and is the answer not in the manual?

THORLABS TC300 Specifications

General IconGeneral
BrandTHORLABS
ModelTC300
CategoryTemperature Controller
LanguageEnglish

Related product manuals