THORLABS TC300 User Manual

TC300 Heater Temperature Controller Chapter 8: Command Line Operation
Page 30 CTN017856-D02
No.
Command Syntax Description
113
Get Ambient Temperature TAMB?
Get the Ambient Temperature=return value
(
Ran
g
e:
(
0 to 100.0 °C
)
, Resolution=0.1 °C
)
114
Get Serial Number of Product SN?
Get Serial Number of Product, 8 digits (e.g.,
12345678
)
115
Get Monitor Message MONITOR?
Return the monitor messages, for details
see Chapter 8.3.37
116
Get Error Message ERR?
Return the error messages, for details see
Chapter 8.3.38
117
Get Warning Message WARN?
Return the warning message, for details see
Chapter 8.3.39
118
Load Factory Parameter LOADFACT! Restore the device factory parameter
8.3. Description of Commands
8.3.1. IDN? – Model Number, Hardware and Firmware Version of TC300
Query model number, hardware, and firmware versions of the TC300 device.
Return:
THORLABS TC300 HV x.xx FV x.xx
where THORLABS TC300 is the model number, HV x.xx is hardware version, and FV x.xx is firmware version for every
device.
8.3.2. ST? – Device Status of TC300
Query device status of the TC300 device. An 8-bit binary digit will be returned. Each bit corresponds to the
following definitions.
Bit Number Definition
bit0 0: CH1 disabled
1: CH1 enabled
bit1 0: CH2 disabled
1: CH2 enabled
bit2 0: Error or Warning
1: Normal operation
bit3 0: No warning
1: Warnin
g
bit4 0: No error
1: Error
bit5 Reserved
bit6 Reserved
bit7 Reserved
8.3.3. EN1=n ; EN2=n – Channel status of TC300
EN command is used to enable channels of TC300 device.
EN1=n
Enable Channel 1 of TC300 device when n=1, disable when n=0
EN2=n
Enable Channel 2 of TC300 device when n=1, disable when n=0

THORLABS TC300 Specifications

General

Brand	THORLABS
Model	TC300
Category	Temperature Controller
Language	English