117
NV10P - Manual - 01 - 2015
SETTING AND COMMISSIONING
7 P R O G R A M M I N G A N D S E T T I N G S
7 PROGRAMMING AND SETTINGS
All relay programming and adjustment operations may be performed through MMI (keyboard and
display) or using a Personal Computer with the aid of the ThySetter software.
7.1 ThySetter SW
The ThySetter sw is a “browser” of data (setting, measure, etc..); it implements an engine that is
afford to rebuild the menu set up and the relationships to data concerning all Thytronic protective
relays by means of XML fi les.
ThySetter installation
The latest release of ThySetter can be downloaded free of charge from the www.thytronic.it site
(Software ThySetter - area download).
ThySetter use
Please refer to ThySetter user manual for detailed instructions.
The document is available on www.thytronic.it site.
WARNING
For safety reasons, a change of the following parameters become active only after an hw reset:
- Relay nominal frequency (f
n
)
- Ethernet communication parameters (IP host address, IP net mask, Autonegotiation).
WARNING
For safety reasons, a change of the following parameters become active only after an hw reset:
- Relay nominal frequency (f
n
)
- Ethernet communication parameters (IP host address, IP net mask, Autonegotiation).
To Next Page
Loading...
Need help?
General
