INTRODUCTION
INTRODUCTION Timbery M100 110819 1-4
Handle fuel/lubricants safely
DANGER! Due to the flammable nature of fuel and oil, never smoke, weld, grind
or allow sparks near your engine or storage tanks, especially during times of
fueling. Doing so may result in serious injury or death.
DANGER! Never allow fuel to spill on a hot engine during fueling operations or
otherwise. The hot temperature of your engine could induce a fire or explosion.
Failure to do so will result in serious injury or death.
DANGER! Store gasoline away from sawdust and other flammable materials.
Failure to do so may result in serious injury or death.
Dispose of sawing by-products properly
CAUTION! Always properly dispose of all sawing by-products, including sawdust and
other debris, coolant, oil, fuel, oil filters and fuel filters. Failure to do so may result in
injury or equipment damage.
Safety for sawmill set-up
WARNING! Do not set up the sawmill on ground with more than a 10 degree
incline. If setup on an incline is necessary, put blocks under one side of the
machine or dig out areas for the legs to keep the sawmill level. Failure to do so
may result in serious injury or death.
Check sawmill before operation
DANGER! Make sure all guards and covers are in place and secured before
operating or towing the sawmill. Failure to do so may result in serious injury
or death.
WARNING! Release the blade tension when the sawmill is not in use
(for example at the end of a shift). Tension the blade again before starting the
engine/motor.
Keep all people away
DANGER! Keep all persons out of the path of moving equipment and logs when
operating the sawmill or loading and turning logs. Failure to do so may result in
serious injury or death.
To Next Page
Loading...