Toa M-864D - Page 6

6
• Whenmovingtheunit,besuretoremoveitspower
supply cord from the wall outlet. Moving the unit
with the power cord connected to the outlet may
cause damage to the power cord, resulting in fire or
electric shock. When removing the power cord, be
sure to hold its plug to pull.
• Donotblocktheventilationslotsontheunit’sboth
sides, top panel, and rear side. Doing so may cause
heat to build up inside the unit and result in fire.
Also, periodically clean the ventilation slots of dust.
• Avoidinstallingtheunitinhumidordustylocations,
in locations exposed to the direct sunlight, near the
heaters, or in locations generating sooty smoke
or steam as doing otherwise may result in fire or
electric shock.
• Besuretofollowtheinstructionsbelowwhenrack-
mounting the unit. Failure to do so may cause a fire
or personal injury.
· Installtheequipmentrackonastable,hardoor.
Fix it with anchor bolts or take other arrangements
to prevent it from falling down.
· Whenconnectingtheunit'spowercordtoanAC
outlet, use the AC outlet with current capacity
allowable to the unit.
(Every version except the M-864D CU for US)
· The supplied rack-mounting screws can be used
for the TOA equipment rack only. Do not use them
for other racks.
(M-864D CU for US)
· Rack-mounting screws are not supplied with the
unit. Prepare them that are appropriate for the
equipment rack.
· Be sure to complete installation and cable
connections before connecting the unit’s power
plug to the power source. When uninstalling the
unit or disconnecting the unit’s cables, be sure to
disconnect the power plug from the power source
rst.Doingotherwisemayresultinelectricshock.
• LANConnectorcannotconnecttoConnectorwhich
might catch overvoltage.
When the Unit is in Use
• (WhenusingtheZM-9011/9012/9013/9014Remote
Control Panel)
Be sure to use the dedicated AC Adapter or its
equivalent.
Using other AC adapter may cause a fire.
• If dust accumulates on the power supply plug or
in the wall AC outlet, a fire may result. Clean it
periodically. In addition, insert the plug in the wall
outlet securely.
• Switchoffthepower,andunplugthepowersupply
plug from the AC outlet for safety purposes when
cleaning or leaving the unit unused for 10 days or
more. Doing otherwise may cause a fire or electric
shock.
Thelightingashwitharrowheadsymbol,withinanequilateraltriangle,isintendedtoalertthe
usertothepresenceofuninsulated"dangerousvoltage"withintheproduct'senclosurethatmay
beofsufcientmagnitudetoconstituteariskofelectricshocktopersons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence
of important operation and maintenance (servicing) instruction in the literature accompanying the
appliance.