Document Ref 941113-001 Rev 2 Page 2-5
Quantium 310 Maintenance Manual Maintenance Procedures - General
2.6 Access to the Cable Glands
The following instructions detail the procedure to be followed for the safe removal of the
side panel(s) in order to access the cable glands.
INSTRUCTIONS
1) Follow the instructions given in section 2.4 to remove the hydraulic
doors on both sides of the dispenser.
2) Locate the relevant side panel to be removed.
3) Using a 3mm allen key, loosen and remove the six screws holding the
side panel to the dispenser frame.
4) Carefully push the side panel up, lift away from the dispenser and
place in a safe position.
2.7 Access the Junction Box Connections
The following instructions detail the procedure to be followed to allow safe access to the
junction box connections.
INSTRUCTIONS
1) Follow the instructions given in section 2.4 to remove the
hydraulic door on side B of the dispenser.
2) Locate the junction box on side B of the dispenser.
3) Using a 6mm allen key, loosen and remove the ten bolts on the
junction box cover. Remove the junction box cover completely
and place in a safe position.
4) Refer to the wiring diagrams in section 7.
5) To re-fit the junction box cover, follow the instructions in reverse.
To Next Page
Loading...