Maintenance Procedures - Hose Quantium 310 Maintenance Manual
Page 3-2 Document Ref 941113-001 Rev 2
3 MAINTENANCE PROCEDURES - HOSE MECHANICS
3.1 Changing a Nozzle
Before starting the maintenance procedure, please refer to section 2.
Identify the relevant nozzle to be replaced.
Tools required
•Replacement nozzle
•Spanner for hose connection (36mm for 16mm hose, 41mm for 21mm hose, 46mm for
25mm hose)
•Spanner for nozzle (36mm, 41mm or 46mm)
INSTRUCTIONS
1) Using one spanner to hold the hose connection stationary,
disconnect the nozzle from the end of the hose using the
second spanner. Drain excess fuel into a suitable container.
WARNING : BEWARE OF FUEL SPILLAGE.
2) Connect the replacement nozzle to the end of the new hose.
3) Ensure all tools and unused materials are removed.
4) Re-instate power to the dispenser.
5) Test for any leakages.
6) Dispose of all waste accordingly.
To Next Page
Loading...