Maintenance Procedures - Hydraulic Quantium 310 Maintenance Manual
Page 4-14 Document Ref 941113-001 Rev 2
5) Follow the instructions given in section 4.5 to remove the
v-belt.
6) Using a 13mm spanner, remove the two screws and nuts on
the meter connection at the top of the pump to disconnect the
fuel outlet pipe.
7) Using a 13mm spanner, loosen and remove the four screws
on the motor support bracket at the bottom of the pump.
8) If vent pipes are fitted as an option, use a 22mm spanner to
disconnect the bolts on the pump unit and driptray. Remove
the vent pipe completely.
9) Pull the motor cabling clear of the filter box.
10) Carefully disconnect the meter(s).
WARNING : BEWARE OF FUEL SPILLAGE.
11) From side B of the dispenser, slide the pump and filter
box out towards the filter box end.
Note : ensure the motor cabling is clear of the filter
box.
WARNING : BEWARE OF FUEL SPILLAGE
DURING THE REMOVAL.
12) Remove the plug/protective hygiene cover on the filter of the new pump.
13) Position the new pump by sliding it into the unit from side B of the dispenser.
Note : ensure the motor cabling is clear of the filter box.
14) Using a 13mm spanner, re-fit the four screws on the support bracket below the pump unit
to secure the pump into position.
15) Using a 13mm spanner, re-fit the two screws and nuts on the fuel outlet pipe on top of the
pump using new o-rings.
16) Follow the instructions given in section 4.5 to re-fit and adjust the motor v-belt.
17) If removed, re-fit the vent pipes.
18) Using a 15mm spanner, re-fit the flexible connection to the filter box.
19) Ensure that all tools and unused materials are removed.
20) Secure the hydraulic doors to both sides of the dispenser and lock.
21) Re-instate power to the dispenser.
22 Test operation of the new pump.
23) Dispose of all waste accordingly.
To Next Page
Loading...