Document Ref 941113-001 Rev 2 Page 5-7
Quantium 310 Maintenance Manual Maintenance Procedures - Electronics
17) Ensuring that the installation of the pulser is complete and correct, apply new Weights &
Measurement seals to the centre plate cover and to the pulser as required.
Note: qualification for carrying out his task may vary by country.
18) Ensure that all tools and unused materials are removed.
19) Re-fit the side panel to the dispenser.
20) Close the calculator head door and lock.
21) Re-fit the hydraulic door(s) and lock.
22) Re-instate power to the dispenser.
23) Test the operation of the new pulser.
24) Dispose of all waste accordingly.
To Next Page
Loading...