Maintenance Procedures - Electronics Quantium 310 Maintenance Manual
Page 5-16 Document Ref 941113-001 Rev 2
PLEXI GLASS ONLY:-
7) Carefully lift out the plexi glass from the display bracket.
8) Position new plexi glass into the display bracket.
RUBBER SEAL ONLY:-
9) Carefully remove plexi glass as described.
10) Carefully remove the rubber seal from the calculator door.
11) Fit new rubber seal to the calculator door.
12) Re-fit plexi glass into the calculator door.
13) Re-fit the eight nuts to secure the display bracket to the calculator door.
14) Where applicable, re-fit the four sealing nuts on the EMT security cover.
15) Where applicable, re-apply the W&M seals to the EMT security cover.
16) Ensure that all tools and unused materials are removed.
17) Close the calculator head door and lock.
18) Re-instate power to the dispenser.
19) Dispose of all waste accordingly.
To Next Page
Loading...
