䕔
3-28
(Fig. 3)
1) Place a dot on a cell.
- Touch the cell selection button (4) to activate it. Specify the center of
each cell using the touch pen.
- A green dot appears at the touched point.
- The “Count” field (3) increases the number of dots every time a cell is
specified.
- To delete a dot, touch the eraser button (5) to activate it and then
touch the dot to be deleted.
- Touching and holding the all delete button (6) deletes all dots
displayed.
- Touch the undo/redo buttons (7) to undo and/or redo the operation to
specify dots.
2) Touch the “Calc. (calculation)" button (8) to close the Point Edit
screen.
- The result of calculation is displayed on the analysis screen.
- Touching the "Cancel" button (9) will discard the edited point
information, and return you to the analysis screen.
c) How to read analysis results
ڦ
The NUM value becomes smaller than the number of dots in the analysis
result of the Core method. Dots near the outermost circumference are not
used for analysis.
(Fig. 4)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
To Next Page
Loading...
Need help?
General