3-7䢢
䕔
3.2.6 Setting the fixation light position
The fixation light to fix the patient’s eye can be turned on in the center, 6
directions in the periphery, and 8 parafovea directions. The center light is
normally used for capturing images, but the peripheral and parafovea
positions are effective when an image cannot be taken with the light in the
center or when capturing an image at optional positions.
1) Touch the fixation light button (1) to display the Fixation Light screen (Fig.
2).
(Fig. 1)(Fig. 2)
2㸧 Touch the appropriate button (2) to select the lighting position.
- Descriptions on each button represent the direction viewed from the
patient.
C : Center, U : Up, R.U : Upper right, R.L : Lower right,
L : Bottom, L.L : Lower left, L.U : Upper left
3㸧 Touch the “Exit” button (3) to close the Fixation Light screen.
- The position of the lit fixation light is shown in orange on the fixation
light button (1) on the capture screen.
3.2.7 Setting capturing conditions
Settings for capturing images can be changed temporarily. Temporary
settings made as described below will be initialized when the “New” button is
touched.
1㸧 Touch the “Setup” button (1) to display the Setup screen (Fig. 2).
(1)
(2)
(3)
(1)
a)
b)
c)
d)
(2)
(Fig.2)
(Fig.1)
To Next Page
Loading...
Need help?
General