Tomos NITRO 50 - Page 38

38
•Electricstartbutton
This is a starting motor button (switch) for engine starting.
With the main switch “ON”, press this button while holding the front or rear brake lever will start the
engine.
•CAUTION:
• Release this button immediately after engine has been starter, and never press the button again to avoid
damaging the engine.
• This mechanism is a safety design. The engine can only be started after the front or rear brake lever has
been applied.
• Do not use light system. Turn signal light to the “OFF” position when the engine is being started.
•High/lowbeamswitch
This is the high and low beam of headlight switch. Press this switch to switch between high and low
beams.
This is for high beam.
This is for low beam. (Please turn to low beam when riding in the city.)
•HornSwitch
Press this button down when ignition switch is in the “ON” position, the horn will sound.
•TurnSignalSwitch
Turn signal lights are used when turning left/right or changing lane.
Turn ignition switch to the “ON” position, and slide the turn signal switch to left or right. Then, the turn
signal lights will flash.
To release, simply return the turn signal light button to the original position.
Left signal light is flashing means you intend to make a left turn.
Right signal light is flashing means you intend to make a right turn.
•Enginestopswitch
This is a button (switch) for stopping the engine.
Turn the ignition switch to the “ON” position, with the engine stop switch “ON”, press the button while
holding the front or rear brake lever and the engine will start.
Turn the ignition switch to the “ON” position, with the engine stop switch “OFF”, the engine will not start.
󱣏
󱣎