Tomos NITRO 50 - Inspection and Maintenance Before Riding; Routine Inspection; Engine Oil Inspection and Change

43
10. INSPECTIONANDMAINTENANCEBEFORERIDING
Pleaserefertothecomponentslocationdiagramforthefollowingcomponents.
ROUTINEINSPECTION
Check Items Check Key Points
Engine Oil Is there enough engine oil?
Fuel Is it enough?
Brake
Front
Braking condition?
(Brake lever free play: 10
~
20mm)
Rear
Braking condition?
(Brake lever free play: 10
~
20mm)
Tires
Front Is tire pressure normal?
Rear Is tire pressure normal?
Steering
Handle
Does the handle vibrating abnormally or is difficult to turn?
Speedometer,
lights, and
rearview mirror
Is it operating properly?
Do lights come on? Can it be seen clearly from behind?
Tightness
of Main
Components
Are screws, nuts loosen?
Abnormal
Points
Do the previous troubles still exist?
•CAUTION:
•If any problem has been found during routine inspection, correct the problem before using the twowheeler
again, have your twowheeler checked and repaired by theTOMOS.
ENGINEOILINSPECTIONANDCHANGE
• INSPECTION:
1. Use the main parking stand to support the twowheeler on a level ground, remove the dipstick after engine
stopped for 3~5 minutes. Wipe oil off the dipstick and
then insert it into the guide tube again (Do not rotate it.)
2. Remove the dipstick and check whether oil level is in
between the upper and lower marks..
• Add oil to upper limit if oil is under the lower limit. (Check
cylinder, crankcase…etc for leakage.)