8. IMPORTANTPOINTSANDCAUTIONSFORSTARTINGENGINE
•CAUTION:
•Please check the oil and fuel levels and make sure they are adequate.
•To start the engine the main parking stand must be firmly on the ground and the brake is applied on the rear
wheel to prevent the twowheeler from moving forward suddenly.
1. Turn ignition switch key to the ”ON” position.
2. Apply hand(foot) rear wheel brake.
3. Do not accelerate, press starter button when the brake is applied.
•CAUTION:
•In order to avoid damaging the starter motor, please do not press the starter button continuously over 15
seconds.
• If engine still can not be started after pressing starter button over 5 times, stop and wait for 10 seconds
before start it again.
•It is harder to get the engine started after the twowheeler has been left idle for a long time or after refueling
when the fuel has been depleted. Then, it is necessary to press the starting lever or starter
•It may need several minutes to warm up engine if it is a cold start.
Whenstartingenginewithstartinglever.
• Turn ignition switch key to the “ON” position. Apply foot brake lever. Press the kick starter forcefully by foot with
the throttle valve handle closed.
• If engine is difficult to start with the starting lever when the engine is cold, rotating the throttle valve 1/8~1/4
turns will make the start easier.
• Put the kick starter back to its original position after the engine has been started.
•CAUTION:
•Firmly support the twowheeler with the main parking stand before starting the engine with the kick starter
arm.
•Start the engine with the kick starter arm occasionally to prevent it from loosing its function because of
unused for a long time.
1/
1/
To Next Page
Loading...
