Topcon GPT-8003A User Manual

8 PARAMETERS SETTING MODE
8-6
3
Press the [F2](Set RS232C) key.
The next steps are same as Section 8.2.1-
Parameters Setting for communication, refer
to the section 8.2.1.
[F2]
 The setting will reset to the default settings by pressing the [F2](I.GTS) key.
(1200baudrate, Even, Stop 1, Delimit ETX, Rec-A Protocol ON, NEZ-REC Standard) Factory default
settings are indicated with underlines in Chapter 8.1.2 “Parameters for communication” .
 In the setting of RC, the settings of Baudrate, data length, Parity and Stop are fixed.
They will be indicated on the screen for your reference.
Though Protocol is not indicated, it is fixed to OFF.(GPT-8000A series)
Parameters (Communication)
B.Rate [1200] 2400 4800 9600
Data.L [ 7 ] 8
Parity none odd [even]
SET I.GTS <- -> ↑ ↓
8.2.3 Password Option
Establishing a Password
A password can be set in the GPT-8000A/8000 series to secure the use of the instrument. Once a
password is established the user can disable the option or change the password. Once a password
established and the option is turned off, the password will always remain in memory. When turning
on the instrument after a password-input screen appears before the self-test mode. Type in your
password and press the [ENTER] to continue.
A maximum of 10 numeric digits can be entered for a password. All zeros (0000000000) or 9`s
(9999999999) are invalid passwords. If 10 unsuccessful attempts are made to input a password, the
instrument will shut off automatically.
Establishing a Password for the first time.
The instructions below show how to establish a password for the first time.
Operating procedure Operation Display
1
From the main menu icons, press [F6](Para)
to access the parameters option menu. To
access the password option, press
[F3](Password).
[F6]
[F3]
2
The password option screen will appear.
When accessing the password option for the
first time, the [OFF] indicator will appear on
the upper left corner of the screen. To
establish a password you can press the
[F5](ON) key to turn on the option and
establish a password.
3
The password-input screen will appear. At the
blinking cursor type in your password and
press the [ENT] key.
IMPORTANT:
DON'T FORGET YOUR PASSWORD.
WRITE THE PASSWORD DOWN ON
A PIECE OF PAPER AND PUT IN A
SAFE PLACE. ONCE A PASSWORD
IS STORED YOU CAN NOT ERASE IT
FROM MEMORY.
[F5]
Ty p e
password
[ENT]
Parameters
F1 Measurement
F2 Communication
F3 Password
Password
[OFF]
EXIT CHANGE ON OFF
Password
Input a password
[ ]
EXIT BS
Password
Input again (confirmation)
[ ]
EXIT BS

Topcon GPT-8003A Specifications

General

Brand	Topcon
Model	GPT-8003A
Category	Measuring Instruments
Language	English