Topcon HiPer SR - Resetting the Receiver (Clearing the NVRAM)

ConfiguringtheReceiver
30
P/N:1000737‐01
• • • • • •
Configuring the Receiver
Thesectionsinthischapterdescribereceiveroptions,andhowtoloadanewOptionAuthorizationFile(OAF),updatefirmware,
andperforma factoryreset.Todothis,youwillneedtousetheTopconReceiverUtility(TRU)softwarethatwassuppliedonthe
HiPerSRCD.Forinformationaboutinstalling
thesoftware,seetheTopconReceiverUtility(TRU)ReferenceManual.
Viewing Receiver Information
Inthe TopconReceiverUtility(TRU),the ReceiverInfo windowdisplaysbasicReceiverinformation,suchashardwareandfirmware
versions,RAMsize,receiverID,serialnumber,etc.
ToopentheReceiverInfowindow:
1. ConnectthereceivertoacomputerandopenTRU.
2. InTRU,connecttothereceiver.
3. ClickDeviceApplicationModeReceiverManaging.
4. ClickDeviceConnect.
5. IntheConnectionParameterswindow,selectthecorrectserialport,andclickConnect.
6. IntheTRUmainwindow, clicktheInformationicon.TheReceiverInfowindow(Figure6)appears.