Topcon HiPer SR - Setting up the Rover Receiver

Field System Setup
SettingUptheRoverReceiver
50
P/N:1000737‐01
Setting Up the Rover Receiver
1. Mountthereceiverontheroverpole,asshowninFigure17.
2. AttachaTopconcontrollertothepole usingamountingbracket.
3. Ifyouarenotusingafixe dheightroverpole,measuretheheightofthereceiverfromtheground.See“Measuring
AntennaHeight”onpage52.
4. Pressthepowerbuttontoturnonthereceiver.Theintegratedwirelessdeviceinthereceiverturnsonwhenthe
receiverispowered.
5. ConnectthereceivertotheBluetooth‐enableddatacollector,runningTopconFieldsoftware,toconfiguretheHiPer
SRasaroverreceiver.
6. ViewtheLEDdisplaypanelforthereceiver’ scurrentstatus.Seealso“DisplayPanelOperations”onpage17.