Topcon HiPer SR - Loading an OAF

Managing Power
UsingInternalandExternalPowerSources
27
P/N:1000737‐01
Charging the Batteries
Whenthebatterychargeislow,theBATLEDchangesfromsolidgreentoyellowandthenred,dependingontheremaining
charge(see
“BatteryLED”onpage24).Whenthereceiverisconnectedtoanexternalpowersource,thebatteriesbeginto
chargewhetherthereceiveristurnedonoroff.
Tochargethebatteries:
1. Connectthesuppliedpowercabletothereceiver’spower/communicationport.
2. ConnectthepowercableSAEconnectortotheSAEconnectorofthepoweradapter.
Table9.OperationHours
Use Description
Approx.
Hours of
Operation
a
a.Whenoperatedat20°C.
LongLINK RTK Base Base sending RTCM3 differential corrections to one Rover. 15
LongLINK RTK or
Network RTK rover
Rover receiving RTCM3 differential corrections over
LongLINK or from a Network site and connected through
Bluetooth to a data collector.
17
Static Survey Static setup logging raw GNSS data at 1 Hz. 20