Topcon SP-3000P - Cautions and Conditions; Basic Cautions for Use; Environmental and Storage Conditions; Maintenance Checkpoints

2
CAUTIONS FOR USE
Basic caution
When moving the chinrest up and down, be careful not to catch the patient's hand.
The patient may be injured.
To avoid electric shock, do not open the instrument.
Request service from an authorized Topcon distributor.
Electric shock may cause burns or a possible fire. Turn the power switch OFF and unplug the power
cord before replacing the fuses.
Replace only with fuses of the correct rating.
Disposal
Dispose of the instrument according to local disposal and recycling laws.
ENVIRONMENTAL CONDITIONS FOR USE
Temperature : 10°C ~ 40°C
Humidity : 30% ~ 75% (without dew condensation)
Air pressure : 700hPa ~ 1060hPa
STORAGE, USAGE PERIOD AND OTHERS
1. Environmental conditions for installation (without package)
Temperature : 10°C ~ 40°C
Humidity : 30% ~ 75% (without dew condensation)
Air pressure : 700hPa ~ 1060hPa
2. When storing the instrument, ensure that the following conditions are met:
(1) The instrument should not be splashed with water.
(2) Store the instrument where air pressure, temperature, humidity, ventilation, sunlight, dust, salty/
sulfurous air, etc. do not give any negative side effect.
(3) Do not store or transport the instrument on a slope or uneven surface or in an area where it is
subject to vibrations or instability.
(4) Do not store the instrument where chemicals are stored or gas is generated.
3. Usage period
8 years from delivery providing regular maintenance is performed (according to the self-certification
[Topcon data])
ENVIRONMENTAL CONDITIONS FOR PACKAGING IN TRANSPORTATION / STORAGE
Temperature : -20°C ~ 50°C
Humidity : 10% ~ 95%
CHECKPOINTS FOR MAINTENANCE
1. Periodically inspect the instrument and its parts.
2. Before using the instrument after a long period of inactivity, make sure that it operates safely and
normally.
3. Be careful not to stain the photography window with fingerprints or dirt. This may affect picture quality.
4. If the photography window is stained, clean it according to the "CLEANING THE PHOTOGRAPHY
WINDOW" instructions on P. 74 in this manual.