Topcon SP-3000P - Cleaning Procedures; Cleaning External Instrument Parts; Cleaning Patient Contact Parts

73
MAINTENANCE
MAINTENANCE
CLEANING THE DUST COVER, CONTROL PANEL, MONITOR SCREEN, ETC.
1 If the dust cover, control panel and monitor screen are dirty, wipe them with a dry cloth.
2 If the dust cover is badly stained, prepare a solution by mixing a neutral detergent for kitchen-
ware with tepid water. Moisten a cloth with the aforementioned solution and wring it thoroughly.
Then, wipe the dust cover with the cloth.
CLEANING THE PARTS WHICH COME INTO CONTACT WITH THE PATIENT
• Stain on forehead rest or chinrest
Prepare a solution by mixing a neutral detergent for kitchenware with tepid water. Moisten a cloth
with the aforementioned solution and wring it thoroughly. Then, wipe the forehead rest and chinrest
with the cloth.
CAUTION
To avoid damage to the instrument or electric shock, turn the power
switch OFF and unplug the power cord before maintenance.
NOTICE
To avoid damage to the instrument or electric shock, do not spray or
splash the instrument with liquid.
NOTICE
Avoid spraying a cleaner directly onto the instrument. In such a case,
detergent or any other fluid may permeate through the vent hole, etc.
which can cause mechanical problems with the instrument.
NOTICE
When not in use, turn off the power switch.
NOTICE
Never wipe the plastic parts of the instrument with volatile solvents. Wip-
ing them with benzine, thinner, ether, gasoline, etc. may cause discolora-
tion and/or deterioration.