33
PREPARATONS BEFORE USE
RESET FROM POWER SAVE STATUS
This instrument features a power saving function. If the instrument is not operated within the set time,
it enters into power saving mode. The power supply stops for the monitor, the CCD camera and the
photography light source.
The "POWER" lamp blinks on the control panel during the Power Save status.
1 To reset the instrument from the power saving status, press the switch on the joy-
stick. After a few seconds, the color video monitor is reset and photography is possible.
"10 minutes" is set as the Power Save time when shipped. If you want to change the set time,
refer to "Setting the power saving time" on P.24.
The images captured before power saving is activated are stored in the memory so you can access
them.
Photography
To Next Page
Loading...
