70-EN
7.1 Restoring the factory settings
1. Press the OPEN(B) and CLOSE(C) buttons at the same time.
Fig.17: Factory settings
2. Press both buttons for approximately 3seconds while pulling out the mains
plug from the mains socket and while reinserting the mains plug again.
7.2 Cycle counter
The cycle counter stores the number of OPEN/CLOSE actions powered by the
drive. To read the meter, hold the button(C) at the drive head for 3seconds until
you see a figure.
The digital display shows the numbers starting from the highest to the lowest
decimal place consecutively. At the end, a horizontal line appears on the display,
for example: 3456movements, 3456–.
To Next Page
Loading...
