3
SAFETY/ WARNINGS SYMBOLS
NOTE indicates important information specific to the process or steps
being performed.
ELECTRICAL VOLTAGE indicates that electrical voltage is present
and that caution should be taken to prevent injury or property damage.
CAUTION indicates failure to follow instructions may result in personal
injury and/ or property damage.
OPTIONAL COMPONENTS indicates components that are not installed
in all systems.
!
WARNING - Failure to observe the information in this manual may result in
personal Injury or damage to equipment. To reduce the risk of
injury of persons use this operator only with pedestrian swing
doors.
Save these instructions for future reference.
Installation and Service
Any and all TORMAX equipment must be installed, serviced and inspected by an AAADM
Certified technician, to meet the current ANSI A156.10 and/ or ANSI A156.19 standard
and any local or state building codes.
The person responsible for the daily operation and maintenance of the system is referred to as
“End-User”.
It is the technicians responsibility:
1. Review the functions of the equipment with the end-user. Failure to do so, may lead to
the improper use, could cause injury to persons and/ or damage to the equipment.
2. Familiarize the end-user with the Daily Safety Check Decal and how to perform the
walk test procedures.
3. Illustrate to the end-user how to place the door out of service (turn off power or place
in P mode or OFF mode of operation), if the equipment does not perform as described
in the Daily Safety Check Decal.
4. Recommend to the end-user to have their equipment inspected annually by an
AAADM certified technician.
Glazing
The glazing material of all doors shall comply with the requirements of ANSI Z97.1, American
National Standard Performance Specifications and Methods of Test for Safety Glazing Material
Used in Buildings.
Important Information
To Next Page
Loading...
Need help?
General
