Toro TIMECUTTER HD 75212 - Page 127

8-14
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
MOWER DECK
Leveling the Mower Deck (Cont.)
6. Measure between the outside cutting edges and the at surface. If all measurements are not within 3/16 in. (5
mm), an adjustment is required.
7. Rotate the blades so that they are perpendicular to the rear of the deck (Figure 14). If the front blade tip is not
1.6 - 7.9 mm (1/16 - 5/16 in.) lower than the rear blade tip, continue with Leveling the Mower Deck.
A
A
A
B
B
B
C
C
C
C
C
C
Figure 14
A. Blades Side-to-Side
B. Outside Cutting Edge
C. Measure from the tip of the
blade to the at surface here