8-15
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
MOWER DECK
Deck
Leveling the Mower Deck (Cont.)
8. Set the anti-scalp rollers to the top position or remove completely for this procedure.
9. Set the height-of-cut lever to the 3 in. (76 mm) position.
10. Place two 6.6 mm (2-5/8 in.) thickness blocks under the front edge of the cutting deck skirt; one on each side
of the cutting deck, but not under the anti-scalp roller brackets.
11. Place two 7.3 mm (2-7/8 in.) thickness blocks under each side of the rear edge of the deck, one on each side
of the deck (Figure 15).
Figure 15
A. Wood Block-6.6 cm
(2-5/8 in.) thick
B. Wood Block-7.3 cm
(2-7/8 in.) thick
C. Front Edge
To Next Page
Loading...
