Glow-Plug Indicator Light
The glow-plug indicator light ( Figure 6 ) illuminates red
when the glow plugs are activated.
Important: The glow-plug indicator light turns
on for an additional 15 seconds when the switch
returns to the S TART position.
Coolant-T emperature Gauge and
Light
The coolant-temperature gauge and light registers the
coolant temperature in the engine and operates only
when the key switch is in O N position ( Figure 6 ).
The 5 coolant bars blink if the engine overheats.
Charge Indicator
The charge indicator illuminates when the battery
discharges. If the light illuminates during operation,
stop the machine, shut of f the engine, and check for
possible causes, such as the alternator belt ( Figure 6 ).
Important: If the alternator belt is loose or
broken, do not operate the machine until the
adjustment or repair is complete. Failure to
observe this precaution may damage the engine.
Check the operation of the warning lights as follows:
• Engage the parking brake.
• T urn the key switch to the O N /P REHEAT position,
but do not start the engine. The coolant
temperature, charge indicator , and oil-pressure
lights should glow . If any light does not function,
either a bulb is burned out or there is a malfunction
in the system that you must repair .
Fuel Gauge
The fuel gauge shows the amount of fuel in the tank.
It displays only when key switch is in the O N position
( Figure 6 ).
A single bar indicates a low fuel level and 1 ashing
bar indicates that the fuel tank is nearly empty .
4-Wheel Drive Switch
4-Wheel Drive Models Only
When the 4WD switch ( Figure 5 ) is on, the machine
automatically engages the 4-wheel drive if the sensor
detects the back wheels spinning freely . When the
4-wheel drive is engaged, the 4WD switch light turns
on.
4WD works only in the forward direction in A UTO
mode. If you want it in R EVERSE , press the 4WD
button.
High-Flow Hydraulics Switch
TC Models Only
T urn on the switch to activate the high-ow hydraulics
( Figure 5 ).
Horn Switch
The horn switch is located on the control panel ( Figure
5 ). Press the horn switch to sound the horn.
T achometer
The tachometer displays the speed of the engine
( Figure 6 ).
Note: 3,300 rpm is the desired engine speed for 540
rpm PT O operation.
Speedometer
The speedometer registers the ground speed of the
machine ( Figure 6 ).
T achometer-Speedometer
Location Change
Button/Speedometer Conversion
Button
Press, hold, and release the button ( Figure 6 ) between
0 to 3 seconds to swap the locations of tachometer
and speedometer .
Press, hold, and release the button ( Figure 6 ) between
3 to 10 seconds to convert the speedometer from
mph to km/h.
Power Point
Use the power point ( Figure 5 ) to power optional 12
V electrical accessories.
18
To Next Page
Loading...
