Toro Workman HDX-D - Page 43

g002373
Figure 36
1. Note the clearance between the ll device and the oil-ll
neck.
8. Install the dipstick rmly in place ( Figure 35 ).
Changing the Engine Oil and Filter
Service Interval : After the rst 50 hours
Every 200 hours
1. Raise the bed and place the safety support on
the extended lift cylinder to hold up the bed.
2. Remove the drain plug and let the oil ow into a
drain pan ( Figure 37 ).
g021292
Figure 37
1. Engine-oil-drain plug
2. Engine-oil lter
3. When the oil stops, install the drain plug.
4. Remove the oil lter ( Figure 37 ).
5. Apply a light coat of clean oil to the new lter
seal before screwing it on.
6. Screw the lter on until the gasket contacts the
mounting plate. Then tighten the lter 1/2 to 2/3
of a turn.
Note: Do not overtighten.
7. Add the specied oil to the crankcase.
Responding to a Check-Engine
Light
Note: Engine-fault code information can be accessed
by your T oro commercial products service staf f only .
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut of f the engine and remove the key .
4. Contact your Authorized Service Dealer .
43