Toro Workman MDX-D Service Manual

Workman MDX--D Page 6 -- 45 Chassis
Removal (Fig. 35)
1. Park machine on a level surface, stop engine, set
parking brake and remove key from the ignition.
2. Remove hood using Figure 35 as a guide.
Installation (Fig. 35)
NOTE: Do not tighten fasteners securing the hood until
all fasteners are in place.
1. Install hood using Figure 35 as a guide. During as-
sembly, use fastener torque specifications that are iden-
tified in Figure 35.
Chassis

Toro Workman MDX-D Specifications

General

Brand	Toro
Model	Workman MDX-D
Category	Utility Vehicle
Language	English