Toro Workman MDX-D Service Manual

Workman MDX--D
Electrical System
Page 5 -- 6
Starting Problems (Continued)
Problem Possible Causes
Engine cranks, but does not start. Fuel tank is empty.
Wiring to start circuits is loose, corroded or damaged
(see electrical drawings in Chapter 7 -- Electrical
Drawings).
Engine or fuel system is malfunctioning (see Chapter 3
-- Diesel Engine).
15 ampere fuse in fuse block is faulty.
Fuel pump or circuit wiring is faulty.
Glow plugs, glow relay or glow plug controller are
faulty.
Wire harness fusible link to run solenoid pull coil is
faulty.
Engine and fuel may be too cold.
Run solenoid is faulty.
General Run Problems
Problem Possible Causes
Battery does not charge. Wiring to the charging circuit components is loose,
corroded or damaged (see electrical drawings in
Chapter 7 -- Electrical Drawings).
Alternator or circuit wiring is faulty.
Battery is faulty.
Engine stops during operation. Wiring to the run circuit components became broken or
disconnected (see electrical drawings in Chapter 7 --
Electrical Drawings).
Engine or fuel system is malfunctioning (see Chapter 3
-- Diesel Engine).

Toro Workman MDX-D Specifications

General

Brand	Toro
Model	Workman MDX-D
Category	Utility Vehicle
Language	English