To Next Page

To Previous Page

Workman MDX--D Electrical SystemPage 5 -- 11

Fusible Links

The Workman MDX--D uses four (4) fusible links for cir-

cuit protection. Three (3) of these fusible links are in-

cluded in a wire harness that connects the starter B+

terminal to the vehicle wire harness (Fig. 12). The re-

maining fusible link is included in the engine wire har-

ness and connects the starter G terminal to the engine

run solenoid pull coil. If any of these links should fail, cur-

rent to the protected circuit will cease. Refer to the elec-

trical schematic and wire harness drawings in Chapter

7 -- Electrical Drawings for additional circuit information.

Testing

Make sure that ignition switch is OFF. Disconnect nega-

tive battery cable from battery terminal and then discon-

nect positive cable from battery (see Battery Service in

the Service and Repairs section of this chapter). Locate

and unplug fusible link connector. Use a multimeter to

make sure that continuity exists between the fusible link

terminals. If a fusible link is open, replace the link.

After testing is complete, make sure that fusible link is

securely attached to engine component and wire har-

ness. Connect positive battery cable to battery terminal

first and then connect negative cable to battery.

Figure 12

FUSIBLE LINK

Electrical

System

Toro Workman MDX-D Service Manual

Other manuals for Toro Workman MDX-D