Workman MDX--D Drive TrainPage 4 -- 41
1. Cable bracket 2. Flange bolt
Figure 55
15 to 18 ft--lb
(21 to 25 N--m)
1
2
NOTE: Keep the gasket sealing surfaces of the cases
as horizontal to each other as possible. If the sealing
surfaces do not join to each other, tap the case lightly
with a plastic hammer.
C. Install case (RH) so each shaft fits properly into
the case.
D. Position cable bracket to transaxle cases.
E. Secure case (RH) to case (LH) with flange bolts
and nuts. Torque bolts from 15 to 18 ft--lb (21 to 25
N--m).
1. Axle bracket 2. Flange bolt
Figure 56
25 to 31 ft--lb
(34to42N--m)
1
2
F. Position axle bracket to each axle case. Secure
axle bracket to each axle case with flange bolts.
Torque bolts from 25 to 31 ft--lb (34 to 42 N--m).
Drive T rain
To Next Page
Loading...
