EasyManuals Logo

Toro Workman MDX-D Service Manual

Toro Workman MDX-D
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #97 background imageLoading...
Page #97 background image
Workman MDX--D Electrical SystemPage 5 -- 21
Backup Alarm (Optional Kit)
When the shift lever is placed in the reverse position, the
backup alarm should sound. The alarm is attached be-
neath the cargo box to a bracket on the right side of the
frame.
Alarm Testing
1. Park vehicle on a level surface, stop engine, apply
parking brake and remove key from ignition switch.
Make sure that vehicle shift lever is in the NEUTRAL
position.
2. Raise and support cargo box to allow access to
backup alarm.
IMPORTANT: Make sure to observe polarity on the
alarm terminals when testing. Damage to the alarm
may result from an improper connection.
3. Disconnect wire harness connector from backup
alarm. Correctly connect 12VDC source to the terminals
(Fig. 29). Alarm should sound.
4. Remove voltage source from the alarm. Replace
alarm if testing determines that it is faulty. Connect wire
harness connector to alarm.
5. Lower and secure cargo box.
1. Alarm top view
2. Alarm bottom view
3. Positive (+) terminal
4. Negative (--) terminal
Figure 29
3
2
4
1
Electrical
System

Table of Contents

Other manuals for Toro Workman MDX-D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toro Workman MDX-D and is the answer not in the manual?

Toro Workman MDX-D Specifications

General IconGeneral
BrandToro
ModelWorkman MDX-D
CategoryUtility Vehicle
LanguageEnglish

Related product manuals