36
program change
T-1 can send and receive MIDI program change messages to control pattern playback.
Incoming MIDI program change messages can be used to queue patterns on the T-1, and outgoing program
change messages can be used to control external devices, for instance change patterns on a secondary se-
quencer.
Program change messages from the T-1 are sent 1/8th note before a pattern change.
Program change values are mapped to match the pattern and bank number values:
• Patterns in Bank 1 to 8 = MIDI channel 1, value 1 to 128
• Patterns in Bank 9 to 16 = MIDI channel 2, value 1 to 128
E.g. pattern 6 in bank 5 = (bank-1) x 16 + pattern = 70
To Next Page
Loading...
