Torso Electronics T-1 - ADJUSTING THE NOTE LENGTH USING SUSTAIN

38
sync
The Sync tab lets you congure synchronization settings for Ableton Link and analog clock.
latency
The clock latency setting allows you to offset the incoming or outgoing clock from the notes generated by
T-1. If you’re experiencing timing issues when syncing with external gear (including Link connected devic-
es) you can use this setting to manually adjust a clock offset.
link
Link Synchronization Enables or disables the wireless synchronization with Ableton Link via WiFi.
Start Stop Sync Sets whether the T-1 reacts to incoming start/stop messages from peers.
clock
The clock section lets you congure the clock rate for the input and output analog clock ports.
T-1 supports the following clock rates:
2, 4, 8, 12, 16, and 24 PPQN (pulses per quarter note)
The clock pulse width on the output can be adjusted from 15 to 85%.
reset
The reset section lets you set if the reset input and output should function as a reset or a run signal.
RESET Sends a short pulse when a pattern starts.
RUN Is high when T-1 is playing and low when stopped.
midi i/o
The MIDI i/o tab lets you congure the MIDI input and outputs on your T-1.
The MIDI i/o tab lets you congure whether the T-1 should send or receive MIDI clock, start/stop, and program
change to and from the USB and MIDI TRS ports. Additionally, a note lter can be enabled on each of the MIDI
outputs, to prevent MIDI notes from being sent on TRS out/out 2 or USB.
thru port functionality
It is possible to congure the functionality of the thru port.
Thru Uses the hardware MIDI-Thru circuit. The MIDI input is directly passed to the thru port.
Out 2 Creates a secondary MIDI output that functions similar to the MIDI output 1.
cv/gate
The CV/Gate tab lets you congure the analog CV/Gate input and outputs on your T-1.