13
note repeater (repeats, time)
The note repeater is a note echo machine that lets you add repeat notes after each pulse. All modulations that
applies to pulses are applied to repeat notes as well. Repeat notes are choked whenever a new pulse is triggered.
• Repeats controls the number of repeats added after each pulse.
• Offset applies velocity ramps to the repeats.
• Time adjusts the note value of the repeats.
• Pace adds acceleration or deceleration to the note value of the repeats.
Link to tutorial video: torsoelectronics.com/tutorials/t1/note-repeater
repeats
Adjusts the number of repeats applied after each pulse. The number of repeats rangesfrom 0-16, and is
shown on the [ VALUE ] buttons in DARK BLUE.
When the ( REPEATS ) knob is turned all the way clockwise, an innite number of repeats is added.
This is indicated on the [ VALUE ] buttons in BLUE light.
Innite repeats remain even when all pulses are removed.
Random affects the number of repeats added after each pulse.
Press ( RANDOM ) + turn ( REPEATS )
choke and tail modes
Repeats are generated in two different modes:
• Choke
• Tail
The two modier buttons in RED lets you switch between tail and choke mode:
• The upper button selects Choke mode.
• The lower button selects Tail mode.
Tail mode can create interesting complex patterns of overlapping arpeggios. Use with innite repeats
and ramp or climb voicing to create very large chords.
Steps
Pulses
Repeats
16
02
06
Offset03
steps
pulses
16
03
steps
pulses
16
06
Each pulse chokes the repeats created by the previous pulse.
The voicing style applies to pulses and repeats equally.
Repeats created by previous pulses are overlayed onto newly created repeats.
The voicing style applies to repeats only - each new pulse resets the voicing.
choke tail
To Next Page
Loading...
