Introduction 17
Overview (_installation, setup, and use
o:, Place the TV in a location where light does not reflect on
the screen.
Place the TV far enough from walls and other objects to
allow proper ventilation. Inadequate ventilation may cause
overheating, which will damage the TV. THIS TYPE OF
DAMAGE IS NOT COVERED UNDER THE TOSHIBA
WARRANTY.
3 Do not plug in any power cords until after you have connected
all cables and devices to your TV.
4 Before connecting cables or devices to the TV, learn the
functions of the TV's connections and controls, see "Overview
of cable types" on page 21.
5 Connect your other electronic device(s) to the TV, see
"Connecting an HDMI® or DVI device to the HDMI® input"
on page 26.
6 Install the batteries in the remote control, see "Installing
batteries" on page 35.
7 See "Learning about the remote control" on page 37 for an
overview of the buttons on the remote control.
8 After connecting all cables and devices, plug in the power
cords for your TV and other devices. Then press tile Power
button on the TV control panel or remote control to turn on the
TV. If the TV stops responding to the buttons on the remote
control or TV control panel and you cannot turn the TV off or
on, unplug the power cords for a few seconds and then plug
them in and try again.
9 See "Navigating the menu system" on page 42 for a quick
overview of navigating the TV's menu system.
10 Program channels into the TV's channel memory "Tuning
channels using the Channel Browser m'' on page 58.
11 For details on using the TV's features, see "Using the TV's
features" on page 54.
12 For help, refer to "Troubleshooting" on page 112.
13 Specifications
14 End User License Agreement
To Next Page
Loading...
