Toshiba B-SA4T User Manual

- 23 -
5. Select the “Local Port”, and click the [New Port]
button.
6. Enter the network path of the shared printer (e.g.
\\*****\TECB-SA4), then click the [OK] button.
7. When the port setting is completed, click the [OK] button to close the “Properties” screen.
Note: After installing this printer driver, be sure to disable the Bi-directional support. For details, refer to Section
6.1 How to Enable Bi-directional Communication Support.
Since the setup information is stored in each PC that shares the printer, please configure the printer driver
settings after the completion of the port setting.

Toshiba B-SA4T Specifications

General

Print Method	Thermal transfer and direct thermal
Resolution	203 dpi
Print Width	104 mm
Interfaces	Serial, Parallel, USB
Optional Interfaces	Ethernet, Wireless
Barcodes	Code 39, Code 128
2D Codes	PDF417, Data Matrix, QR Code, MaxiCode
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-20 - 60 °C (-4 - 140 °F)
Humidity	20% to 85% (non-condensing)
Interface	USB, Serial (RS-232), Parallel, Ethernet, Wireless