<Device Line Substitution>
When enabled, the driver will try to use the printer's
Line Commands to draw lines.
When disabled, lines are drawn by using the
Graphic Command.
<Default Copies>
Allows setting the number of copies to be printed as
default. If the number of copies is not changed
in the application, this value will be effective.
<Disable Copies Limit>
When enabled, a value exceeding “9999” can be
set for the “Default Copies”.
<Disable User-Defined Paper Size>
When this checkbox is checked, the user-defined
paper size “USER” cannot be used.
<Disable Page Size Sharing>
Shows the printer’s available resolution.
Allows creating the illusion of different shades of
gray by varying the pattern of dots.
<Color Adjustment>
Allows the flip horizontal, flip vertical, rotation, color
balance adjustment, etc.
<Dithering Setup>
Allows detailed setting for the selected dithering
method.
<Color Control>
Allows setting the color processing.
<Print Method>
Allows selecting whether the ribbon is used (thermal
transfer) or not (Direct thermal).
<Sensor>
Allows selecting a sensor type used to detect a print
start position.
<Label Gap>
Allows setting the length of the gap between labels.
<Issue Mode>
Allows selecting whether the labels are issued in the
strip mode.
<Post-Print>
Allows selecting whether the labels are issued in the
cut mode. Note that the Pause is not supported.
<Occurrence>
Allows selecting the cutter operation and specifying
how often labels should be cut.
<Interval>
Specifies the number of labels to be printed before a
cut operation. The cutter will cut labels after the
specified number of labels is printed.
<Print Speed>
Allows setting the print speed.
<Feed>
Specifies the length of label that will feed after
printing.
To Next Page
Loading...
Need help?
General
