Toshiba e-studio 160 - Offset Copying

1
2
3
4
5
6
7
9
10
11
12
8
6-6
FINISHING MODE SELECTION
4. OFFSET COPYING
1
Place the originals in the feeder or on the glass.
Select the desired number of copies, image density
and reproduction ratio.
3
Select the OFFSET mode.
• Select “NONSORT/OFFSET” or “SORT/OFFSET” from the
FINISHING menu by pressing the
key. Then press
the
key.
2
Press the key. The “FINISHING” screen appears.
• When the offset tray is full, the following message appears:
Remove paper from offset.
Remove the copies from the tray and press the
key to
continue.
• Refer to the procedures described in “NON-SORT
COPYING” when “NONSORT/OFFSET” is selected.
Page 6-3
• Refer to the procedures described in “SORT COPYING”
when “SORT/OFFSET” is selected. Page 6-4
READY 1
FINISHING:
SORT/OFFSET
NONSORT
NONSORT/OFFSET
When the Offset Tray or Finisher is attached, the sets of copies that are collated or stacked in groups are
output in one pile but each set is offset, as illustrated.
Example: Making 6 sets of copies from 3-page originals. (Bypass copying is not possible in the offset
mode.)
3
2
1
1
1
1