7-27
1
2
3
4
5
6
7
9
10
11
12
8
When the message display shows the following message, copying cannot be performed any longer.
7. CALLING FOR SERVICE
The telephone number of your service technician will be displayed (if pre-programmed).
Note the phone number, then turn the power off and immediately call for service.
Note
Since a heater is used to fix toner images to the copy paper, a safety circuit is incorporated in the
digital multi function system. After you turn on the power switch, if a certain temperature is not attained
within a certain period of time, the safety circuit assumes that something abnormal has happened.
This causes the operation of the digital multi function system to stop and display Call for service. This
can occur when the temperature is low even though the digital multi function system is not
malfunctioning. If this occurs, turn the power switch off and then on again. Repeat this procedure
twice. If the problem still persists, turn off the power switch and call for service.
Call for service
To Next Page
Loading...
