Toshiba e-studio 160 - Flow Charts; Flow Chart - Copying using Cassette 1

4-27
1
2
3
4
5
6
7
9
10
11
12
8
11. JOB MEMORY
You can store and recall a combination of frequently used copy modes at any time.
In addition to reproduction ratios, image density, copy quantities, editing modes, duplex copying modes
and image shift modes can be stored. Storage is available for up to four combinations.
1
Select desired copy modes.
Examples:
Reproduction ratio ........ 85%
Copy quantity ............... 30
Image density ............... Automatic
Copy size ..................... Letter-R
• Check that each mode is correctly set.
2
Press the key on the control panel while in the
initial screen for copying. The “EDIT MENU” screen
appears.
3
Press the key to display “JOB MEMORY.” Then
press the key.
4
Select “MEMORY” by pressing the key.
Then press the key.
5
Select the job number to be saved from “MEMORY1”
to “MEMORY4.” Then press the key.
Tip
When a memory location (with a copy job programmed) is
selected, the Job Memory icon is highlighted.
The stored copy mode is not erased when the digital multi
function system is turned off. When a job number with a copy
mode already stored is selected, the stored copy mode is
deleted and replaced by a new copy mode.
READY 1
EDITING :OFF
JOB BUILD :OFF
JOB MEMORY
JOB MEMORY 1
RECALL
MEMORY
Storing a New Combination of Copy Modes
6
Press the key to return to the initial screen for
copying.
MEMORY 1
MEMORY1
MEMORY2
MEMORY3
MEMORY4