Toshiba e-studio 160 - Exposure Lamp Control; Exposure Lamp Structure and Behavior

6-7
1
2
3
4
5
6
7
9
10
11
12
8
5. ALTERNATION
In this copying mode, as sets of copies are output, the sets are alternated - lengthwise and crosswise -
on top of each other. (Optional cassette or Stack Feed Bypass is required.) LT/LT-R paper only is available
in this mode. When the Finisher is attached, this mode cannot be selected.
1
Place the originals in the feeder.
3
Select the “ALTERNATION” mode.
• Select “ALTERNATION” from the FINISHING menu by
pressing the
key. Then press the key.
4
Key in the desired copy quantity using the numeric
keys.
5
Select the desired image density and reproduction
ratio.
6
Press the key.
• The digital multi function system starts copying. In this
copying mode, as sets of copies are output, the sets are
alternated - lengthwise and crosswise - on top of each other.
2
Press the key. The “FINISHING” screen appears.
When Using the Automatic Document Feeder (optional) or
the Reversing Automatic Document Feeder (optional)
READY 1
FINISHING:
NONSORT
NONSORT/OFFSET
ALTERNATION