Toshiba e-studio 160 - Disassembly and Replacement (Copying Process); Developer Material Removal; Main Charger Wire Cleaning Pad Removal

1
2
3
4
5
6
7
9
10
11
12
8
4-10
EDIT MENU
This copying mode requires the automatic duplexing unit (optional) to be installed.
1
Press the key on the control panel while in the
initial screen for copying. The “EDIT MENU” screen
appears.
2
Confirm that “DUPLEX” is highlighted on the screen.
Then press the key.
3
Select “BOOK > 2” by pressing the key.
4
Press the key.
7
Specify the Book Margin then press the key, as
necessary.
• Press the or key to specify the Book Margin.
Each time either of the keys is pressed, a value is
incremented or decremented by 1mm.
• Press the
key to increment, or key to
decrement the value.
• Specify the value within a range of 8 mm to 30 mm.
6
Press the key.
READY 1
DUPLEX :1 > 1
DUAL TYPE :OFF
IMAGE SHIFT :OFF
Book-Type Originals > 2-Sided Copies
5
Select the start and end page.
• Select the desired copy mode using the or
key.
• RIGHT > RIGHT
Copying is started from a right page of the book and it ends
on a right page.
• RIGHT > LEFT
Copying is started from a right page of the book and it ends
on a left page.
• LEFT > LEFT
Copying is started from a left page of the book and it ends
on a left page.
• LEFT > RIGHT
Copying is started from a left page of the book and it ends
on a right page.
1. DUPLEX COPYING (Cont.)
DUPLEX 1
Original > Copy
2 > 1
BOOK > 2
BOOK > 2 1
RIGHT > RIGHT
RIGHT > LEFT
LEFT > LEFT
8
Press the key.
BOOK MARGIN 1
30mm
15mm
8mm