Toshiba e-studio 160 - Damp Heater Control Circuit

7-3
1
2
3
4
5
6
7
9
10
11
12
8
2. LOADING PAPER
When the paper supply in the selected paper cassette runs out, the Recording Paper Lamp flashes and
the following message appears:
1
Pull the cassette grip up and pull, out the cassette
carefully until it comes to a stop.
2
Open a paper package, take out the whole ream of
paper and place it in the cassette.
• Up to 550 sheets of paper (recommended by Toshiba) can
be set in each cassette.
• Do not add paper above the line indicated on the guide.
• Do not use creased, folded, wrinkled or damp sheets of
paper.
3
Push the cassette straight in until it comes to a stop.
• Be sure to push the cassette in carefully and fully.
CASSETTE1 empty
Open CASSETTE1
Load Paper
Close CASSETTE1
Adding Paper to the Cassettes
Note
Make sure that a gap of approx. 0.02 inch (less than 0.04 inch
in total) is left between the paper and the side guide. No gap
causes paper misfeeding.
Approx.
0.02inch
Approx.
0.02inch
Side guide
Side guide