1.TROUBLESHOOTING FOR THE HARDWARE
Refilling With Staples 61
1 TROUBLESHOOTING FOR THE HARDWARE
9
Close the front cover of the Finisher.
When the message “READY (CHECK STAPLER)” is displayed, test stapling starts automatically.
Test stapling is necessary to prevent void stapling. Note that the test stapling starts automatically when the two
requirements on step 8 are met with the front cover of the Finisher closed. If the test stapling does not start,
make sure again of the two requirements. Then open and again close the front cover.
To Next Page
Loading...
Need help?
General
