Toshiba E-studio 281c - Cannot Print this Paper Size Select the Other Drawer

338
10.WHEN THIS MESSAGE APPEARS
10
11. “Cannot print this paper size Select the other drawer”
When the finisher is installed, A3-Wide paper cannot exit to the receiving tray.
When this message appears, delete the print job, change the paper size you set for printing or specify the
finisher as an exit tray, and tray again.
Printing can be performed without deleting the print job in the following two ways. However, some parts of
the original image may be missing because the paper size smaller than A3-Wide will be used in both
cases.
• Select a drawer button to be set as a paper source on the touch panel, and press the [START] button.
• Place paper other than A3-Wide size on the bypass tray and press the [START] button.
Be sure to specify the paper size.