42
1.BEFORE USING EQUIPMENT
1
3. Energy Saving Mode
This equipment supports two energy saving modes; the Automatic Energy Save mode and the Sleep
Mode.
Automatic Energy Save
The equipment enters the Automatic Energy Save mode automatically after a specified period of time
*1
since its last use. During this mode, “Saving energy – Press START button” appears on the touch panel.
Sleep Mode
The equipment enters the Sleep Mode automatically after a specified period of time
*2
since its last use.
During this mode, the message of the Automatic Energy Save mode disappears and the [ENERGY
SAVER] button lights in green.
These modes are automatically cleared upon the reception of print data, Fax data, Internet Fax data or E-
mails. They are also cleared by pressing the [START] button.
*1 This period is set at 15 minutes by factory default.
*2 This period is set at 60 minutes for the e-STUDIO281c/351c and 90 minutes for the e-STUDIO451c by
factory default.
See the User Functions Guide to change the default settings noted above.
The equipment can also be made to enter the sleep mode manually by means of the following procedure.
2
Press the [SLEEP] button on the touch panel.
• The equipment enters into the sleep mode. During this mode, the display on the touch panel disappears and
the [ENERGY SAVER] button lights in green.
To canceling the energy saving mode
Press the [START] button on the control panel. The sleep mode is cleared and the equipment will be ready
for copying.
The sleep mode is also cleared by pressing any button of [ENERGY SAVER], [COPY], [SCAN], [FAX] and
[e-FILING].
1
Press the [ENERGY SAVER] button on
the control panel.
To Next Page
Loading...
Need help?
General
